Rice Lake Counting Scales - IQ6500 Installation and Operation Manual - Manual (Page 20)

17
5.3 Delete Items from Memory
The following sections contain procedures for deleting items from the memory of your IQ6200/6500.
5.3.1 Deleting a Particular Code
1. Press MODE to enter program mode.
2. Enter code to be deleted.
3. Press #, then press CLEAR.
4. Press MODE to return to weighing mode. The selected code is deleted.
5.3.2 Deleting Entire Memory
Notice:
This procedure erases all unit weights, inventories, setpoints, tare weights, code numbers and part numbers.
1. Press MODE to enter program mode.
2. Press and hold REZERO while pressing “.” twice, then press 0. Release REZERO.
3. Press CLEAR.
4. Press MODE to return to weighing mode.
5.3.3 Deleting All Inventory Values from Memory
1. Press MODE to enter program mode.
2. Press and hold REZERO while pressing “.” twice, then press 1. Release REZERO.
3. Press CLEAR.
4. Press MODE to return to weighing mode. All inventory values are deleted.
5.3.4 Deleting All Unit Weights from Memory
1. Press MODE to enter program mode.
2. Press and hold REZERO while pressing “.” twice, then press 2. Release REZERO.
3. Press CLEAR.
4. Press MODE to return to weighing mode. All unit weights are deleted.
5.3.5 Deleting All Tare Weights from Memory
1. Press MODE to enter program mode
2. Press and hold REZERO while pressing “.” twice, then press 3. Release REZERO.
3. Press CLEAR.
4. Press MODE to return to weighing mode. All tare weights are deleted.
5.3.6 Deleting All Part Numbers from Memory
1. Press MODE to enter program mode.
2. Press and hold REZERO while pressing “.” twice, then press 4. Release REZERO.
3. Press CLEAR.
4. Press MODE to return to weighing mode. All inventory part numbers are deleted.