Rice Lake Counting Scales - IQ6500 Installation and Operation Manual - Manual (Page 19)

16
5.1 Programming Unit Weight for a Code Number in Weighing Mode
1. In weighing mode, key in code number and press #. The displays respond with preprogrammed
information. If code number entered has not been programmed into memory, Quantity display shows
“not F”. If code number is to be entered into memory, press # to enter it, or press CLEAR to clear
display.
2. Enter unit weight (if known) with keypad. If unit weight is not known, use sample procedure at
beginning of this section.
3. Press UNIT WEIGHT. The new code number and its associated unit weight are now in memory. All
other items for this code number must be entered while in program mode.
4. Press MODE. The Weight display shows ProG.
5. Enter code number and press #. The Quantity display shows CLEAr.
6. Press #. Enter other values as above.
5.1.1 Reviewing Code Numbers Already in Memory
1. Press MODE. The Weight display shows ProG. The Quantity display shows letter C and total number
of codes in memory.
2. Press #. The first code is shown in Weight display. The Quantity display shows C 1.
3. Press +. The second code is shown in Weight display. The Quantity display shows C 2. Pressing +
advances to next code, pressing - goes to previously displayed code.
4. Press MODE twice to exit and return to weighing mode.
5.2 Check or Change Code Number Data
1. Press MODE.
2. Enter code number.
3. Press # twice.
4. See the following table for valid options.
To check: Press:
Set 1 +
Set 2 + (again)
Alternate Part Number PARTS#
Inventory NET/GROSS
5. Press * to save information.
6. Press MODE to return to weighing mode.
Note:
If a tare weight has been programmed, it will be displayed in Weight display after step 3 above. Pressing
TARE will erase tare value and set it to 0. Do not press TARE if the preprogrammed value is correct.
5.2.1 Printing Code Number Formats
If your IQ6500 is connected to a tape printer, you can print the format of any code number in memory.
1. From weighing mode, press MODE. The number of code numbers is displayed in the Quantity
window.
2. Press * to print each code number and its associated data.
3. Press MODE to return to weighing mode.
To print ticket in weighing mode:
1. Enter the code number you want to print, then press #.
2. Add weight or sample to be counted.
3. Press + to add to accumulation, – to subtract from accumulation.
4. Press * to print accumulated total.