Rice Lake OnTrak Truck Scale Data Management - Operation Manual - Manual (Page 16)

12 OnTrak Manual
9. Under Scale Two , select Kiosk. In the right pane, mark the checkbox to enable automated kiosk for scale
two. Use the pull-down menus to specify the kiosk communications method, printer driver, and
Windows printer name.
10. Under Scale One , select Kiosk Communications. The right pane’s options will depend on the kiosk
communications method selected in Step 9.
11. If TCP/IP was selected for the kiosk communications method in Step 9, specify the IP address and TCP
port.
Figure 3-10. Kiosk Communications settings. TCP/IP (left) RS-232 (right).
12. If RS-232 was selected for the kiosk communications method in Step 9, use the drop-down menus to
specify the communications port, data bits, stop bits, baud rate, and parity.
13. Click Save .
3.3 Ticket Formatting
OnTrak supplies you with a powerful editor to format your inbound and outbound tickets, and audits--which can
be set to print any additional information at weigh-out. You can use the ticket editor’s toolbar buttons (shown in
Table 3-1) to insert pre-coded tokens, or manually enter them. Refer to Table 3-2 on page 14 for a list of ticket
formatting tokens you can manually enter.
1. From the Tools menu, select Options.
The Options dialog box appears.
Figure 3-11. Options dialog box, Receiving Inbound Format selected.