Rice Lake Ranger Count 3000 Series, Ohaus - Manual (Page 17)

Ranger™ Count 3000 Series EN-15
4.3 Setup Menu
Enter this menu to set scale parameters. Default settings are in bold.
Reset
[reset]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Dual Scale [d.scale]
Set the status of the second scale input (Scale 2).
OFF = disabled
ON = enabled
Cap2 [CAP2]
Set the capacity of Scale 2.
1… 9999
Grad2 [GrAd2]
Set the readability of Scale 2.
0.00005…0.5
Power on unit
[pwWr.UN]
Set the unit of measure displayed at startup.
AUTO = last unit in use when turned off
kg = kilograms
g = grams
lb = pounds
oz = ounces
lb:oz = pound ounces
Zero Range
[ZErO]
Set the percentage of scale capacity that may be zeroed.
2% = zero up to 2 percent of capacity
10% = zero up to 10 percent of capacity
Auto Opt [A.OPt]
Set the Automatic Optimization.
OFF = disabled
ON = APW automatically optimized
Reset:
no
, yes
Dual Scale:
off
, on
Cap2:
1
…9999
Grad2: 0.00005…0.5
Power on unit:
auto
, kg, g, lb, oz, lb:oz
Zero Range: 2%, 10%
Auto Opt: off, on
Auto Tare: on, off, on-acc
Beeper Opt: off, on
Beeper Signal:
off
, accept, under, over, under-over
Beeper Key:
off
, on
Accumulation: off, auto, manual
End Setup: Exit menu