Rice Lake SURVIVOR OTR Steel Deck - Manual (Page 12)

8 OTR Truck Scale Assembly Instructions
3.2 Place and Attach Adjoining Modules B and C
In a scale with more than two modules, the next module is a B module (see Figure 3-5); if the scale has only two
modules, it is a C module. Place two 5 1/2" setting blocks at the corners opposite of the module support pins (load
cell mount locations) to support the B module.
Figure 3-5. Module B Installation
Place the B module so that the module-support pins engage with the pin-connection receptacles (see Figure 3-6) of
module A and the opposite end rests on the two setting blocks.
Figure 3-6. Pin and Receptacle Interface
If the pins do not seat squarely in the receptacles, raise the module slightly, and then reset the module again.
When the B module is in place, remove the cables or chains from the module and install any other B modules or the
C module in a similar manner.
The C module is installed in the same way that the B module was installed. The end of the C module should be
approximately 3/4" from the approach bulkhead.
The weigh module setup is now complete and the scale is ready to be leveled.
Note