Torbal BAS Series - Manual (Page 12)

- 11 -
1. The scale should be properly zeroed before weighing. Proper zeroing is indicated by the Zero
Indicator ( →0←
) on the display. If the display signals an out of zero condition (----), press the
( →0←
) key to Zero an empty pan.
2. Weighing allows taring over the entire weight range. This is accomplished by pressing the Tare
key, ( →
T
←
). Care should be exercised when tare is in use to be sure that the scale’s maximum
capacity is not overloaded.
3. An accurate weighing result should not be taken until the stability indicator, ( ) , indicates that
the result is stable, and the hanging load is stable from swiveling.
4. For best results place the unknown weight in the center of the pan.
5. Always protect the scale from dirt, dust, and corrosive liquids. When Cleaning use of a clean cloth
with soap and water, and then dry with a clean wiper.
6. Use the “Active” function to customize the scale’s main menu and disable functions that are not used.
This makes use the main menu fast and easy.
7. Always secure the weighing load on the hook with extra caution to make sure it will not fall off.
Never overload the scale in excess of 20% of the scale’s rated maximum
capacity.
Chapter 8: Basic Principles of Weighing