Adding cards – Dell Dimension 8100 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To replace the AGP card brace:
1 Insert the tab on one end of the brace into the slot at the front of the
computer.
2 Lower the brace, ensuring that the AGP retention lever on the bottom
of the brace is aligned with the top of the AGP card (see page 48).
3 Replace the screw that secures the brace to the computer.
Adding Cards
The computer has the following slots for the following cards:
•
Up to five 55-MHz 52-bit PCI cards.
•
One 52-bit AGP card. The slot supports AGP 4x or 2x modes operating
at 1.5-9
CAUTION: Before connecting a peripheral to the computer or adding a
component to the system board, verify that the standby power LED on the
system board (see page 45) is off.
A d d i n g P a r t ^ I 4 9