Dell Dimension 8100 User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
7 Slide the new drive/braeket assembly into the drive bay until both
drive braeket tabs snap seeurely into plaee.
drive bracket assembly
drive bracket tab
0
NOTICE: To avoid possible damage when you perform the following step, you
must match the colored strip on the interface cable with pin 1 on both the drive
and system board connectors.
8
Conneet the interfaee eable for the drive.
If you are installing an EIDE deviee, make sure that the interfaee eable
is properly eonneeted to the EIDE eonneetor on the system board.
A d d i n g P a r t ^ I 5 7
Advertising