B&C Technologies EL-6 Windows - Manual (Page 40)

• Max Spin RPM
Sets the scaling so that the control can properly control the inverter drive. Adjustment of this
parameter will very likely cause the machine to never extract. Other speeds will be off, but
the dead giveaway is no extract. Do not adjust.
• Max Spin water level
Should never need adjustment. Setting this lower than 10cm can cause the machine not to
spin. Setting it to 0cm will just about guarantee that the machine won’t spin.
• Maintenance request
Sets the number of programs needed to trigger the maintenance alarm. Typically 450 pro-
grams is about a monthly reminder.
• Temperature regulation
Controls the amount the temperature can drop before the heat is turned back on. 3 degrees
Celsius is typical.
37