Axesstel PST User Manual
Page 101
AXESSTEL Software User's Guide
Contents
phone. The data file is treated as binary, and no translation is
applied to its contents. Any data returned by the phone is displayed
in the scripting window in HEX and ASCII.
Syntax
send_data_file
“file_name”
SEQ_NUMS
Requests that packets be sent with sequence numbers included.
Syntax
seq_nums
SER_REPORT
Reports the Symbol Error Rate (SER) counts, but does not reset them.
Syntax
ser_report
Example
ser_report
Script Command List
Response
Polls the subscriber station for current SER statistics, without
resetting the counters.
SER_RESET
Resets the Symbol Error Rate (SER) statistics.
Syntax
ser_reset
Example
ser_reset
Response
Resets the SER counters.
SET ATTN (analog test command)
Sets the analog power control to a specific value (range 07).
Syntax
set attn
[value]
Example
set_attn 1
Response
Power control is set to 1 volt.
SET_EXT_INT_TYPE
Sets the type of interrupt (0–2). This command is for Module targets
only.
Syntax
set_ext_int_type
0 | 1 | 2
SET EXT_RSSI
Sets the sensitivity and range of RSSI reporting for both CDMA and
analog modes. This command is for Module targets only.
Syntax
set ext_rssi
{cmd_code, sub_sys, subcmd_code, cdma_rssi_sensitivity,
cdma_lower_threshold
, cdma_upper_threshold, analog_rssi_sensitivity,
analog_lower_threshold
, analog_upper_threshold}
cmd_code
is a 1-byte message ID.
sub_sys
is a 1-byte identifier for the generic subsystem, used for
AXESSTEL Proprietary
101