C. Crane BC75XLT - Manual (Page 24)

24
inside the battery compartment is a switch; set the unit to
either ALK or Ni-MH to match the type of battery you’re
using.
WARNING! Non-rechargeable batteries can get hot or
burst if you try to charge them.
CAUTIONS:
• When flashes in the display and the scanner
beeps every 15 seconds, recharge or replace the
batteries .
• Use only fresh batteries of the required size and
recommended type .
• Always remove old or weak batteries . batteries can
leak chemicals that destroy electronic circuits .
• Do not mix old and new batteries, different types of
batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities .
Installing Non-Rechargeable Batteries
1. Make sure the power is turned off.
2. Slide the battery compartment cover off.
3. Use a pointed object such as a ballpoint pen to set the
battery selection switch inside the compartment to
ALK.
4. insert the batteries as indicated by the polarity symbols
(+ and -) marked inside the battery compartment.
5. replace the battery compartment cover.
Installing Rechargeable 2300mAh Ni-MH Batteries
You can also use two ni-MH rechargeable batteries to power
your scanner.