C. Crane BC75XLT - Manual (Page 25)

25
1. Make sure the power is turned off.
2. Slide the battery compartment cover off.
3. Use a pointed object such as a ballpoint pen to set the
battery selection switch inside the compartment to
Ni-MH.
4. install two batteries in the compartment as indicated by
the polarity symbols (+ and -) marked inside the battery
compartment.
5. replace the battery compartment cover.
Note: To prevent damage to Ni-MH batteries, never charge
them in an area where the temperature is above 113°F (45°C) or
below 40°F (4°C).
Charging the Ni-MH Batteries through USB Connection
The scanner has a built-in circuit to charge the ni-MH
batteries when a USB cable connects it to a computer (nOT
to a USB hub) or to an AC or dC adapter that provides USB
charging power. Verify that the battery selection switch is
set to Ni-MH and that only ni-MH rechargeable batteries
are inserted in the scanner before connecting it to your
computer.
CAUTION: Never attempt to charge non-rechargeable
batteries or install non-rechargeable batteries when
the battery selection switch is set to Ni-MH .
1. Be sure the scanner is turned off. it will recharge only if
it is turned off, even with the USB cable connecting it to
a computer.
2. Connect the included USB cable to the scanner’s USB
port.