C. Crane BC75XLT - Manual (Page 40)

40
displays at (or disappears from) the top of the screen,
showing the currently enabled banks.
The scanner scans all the channels within the displayed
banks that are not locked out. The bank number flashes
when the scanner scans a channel that belongs to that bank.
You can manually select any channel within a bank, even if
that bank is disabled. You cannot, however, disable all banks.
One bank must always be enabled.
Scan the Stored Channels
Press Scan. The scanner scans through all non-locked out
channels in enabled banks. (See page 44 for more information
on locking out channels.) When the scanner finds a
transmission, it stops on it. When the transmission ends, the
scanner resumes scanning.
Notes:
• if you have not stored frequencies into any channels,
the scanner does not scan.
• if the scanner picks up unwanted partial or very weak
transmissions, press Func and press the scroll control
knob.
SqL displays. Turn the knob clockwise to decrease
the scanner’s sensitivity to these signals. To listen to a
weak or distant station, turn the knob counterclockwise.
• Adjust squelch until the audio mutes.
Manually Select a Channel
You can continuously monitor a single channel without
scanning. This is useful if you hear an emergency broadcast
on a channel and do not want to miss any details - even
though there might be periods of silence - or if you want to
monitor a specific channel.