CANOGA PERKINS 9145 Network Interface Device - Manual (Page 58)

3-40 9145 Network Interface Device
• Trap/Notification Port
UDP Port number for the destination. Range is 1 to 65535, typically set to 162
• Notification Type
Sets the SNMP version and configuration
V1-Trap: Unacknowledged message with SNMPv1 protocol
V2c-Trap: Unacknowledged message with SNMPv2c protocol
V2c-Inform: Acknowledged message with SNMPv2c protocol
V3-Trap:
Unacknowledged message with SNMPv3 authentication and optional
message encryption
V3-Inform: Acknowledged message with SNMPv3 authentication and optional
message encryption
• Community Name
Enter the V1-Trap, V2-Trap, or V2c-Inform notification Community Name. Up to 10
characters.
SNMPv3- Trap Notification
Pressing <Space> cycles through security options when SNMPv3 Trap Notification is
selected.
Security Name: The name of the 9145 user account.
Security Level: No Auth/No Priv - No user authentication or message
encryption
Auth/No Priv - Authentication by user name, no message
encryption
Auth/Priv - Authentication by user name and message
encryption
• SNMPv3- Inform Notification
To configure SNMPv3-Inform notification, either type [a] value and press <Enter> or
press <Space> to cycle through the options for these parameters:
• Security Name: Enter the name of the user account at the destination. Up
to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination. 64 Hex
characters.
• Authentication Protocol: Notification authentication. Option are MD5, SHA, or
None.
• Authentication Password: The password that generates the authentication key for
the message when the authentication protocol is MD5
or SHA. 8 to 15 characters.