Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 107)

107
5. Configuring the Receiver Technical Reference Manual-4.0.0en
To define your own Id Template press
NEW (F2).
Pt Id. Mode - Is the Mode how the Pt
Template will be used. If you select
Remain Running and you enter a
different Point Id manually in the
Survey panel the new Point Id will be
used as the new Id Template. The
following Point Id’s will then be based
on this new Template. If you select
Change to Indiv. and then enter a
Point Id manually in the Survey panel
the Point Id will return to the Id
Template as it is defined.
Id - Displays the way in which the
template is currently configured. You
may also enter any standard text here
that you would like to see in the Id
Template. (In this example the
standard text is the word “Point”. The
# symbols indicate automatically
incrementing numbers).
Note that leading spaces cannot be
accepted.
Num Start - Defines the start position
of any automatically incrementing
number.
Num End - Defines the end position
of any automatically incrementing
number.
Auto Inc - Defines whether the
number will increment automatically
at subsequent points.
Num Inc - Defines the amount by
which any automatically incrementing
number will increment.You may enter
a negative increment if required.
Cursor Pos - Defines the position at
which the cursor will start at.
Press CONT (F1) until you return to
the CONFIGURE\ Id Templates
screen.
To edit an existing Id Template press
EDIT (F3).
To delete an existing Id Template
press DEL (F4).
Further options are available on this
screen in Advanced mode. See
section 5.2.1 for details.