Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 253)

253 9. The CONFIG Key Technical Reference Manual-4.0.0en
The Hidden Point interface enables
you to configure the port and device
used for Hidden Point measurements.
The port (1,2 or 3) and the device are
displayed. Set the focus on Hidden
Point and press EDIT (F3) to modify
the Hidden Point device.
If you want to use an external device
set Use Device to YES.
Select the port to which the device is
connected. Use the DEVCE (F5) key
to configure the device itself. For
information about all supported
Hidden Point devices refer to
Appendix H.
If no device is connected the Hidden
Point measurement may also be
entered manually. The parameters for
Hidden Point measurements can be
configured in CONFIGURE\ Survey,
Point..., Hidden Point. Refer to
Chapter 5 for further details.
9.13 Interfaces - Hidden Point
The GSI/User Out interface enables
you to export a job with a format file
through a port on the sensor to a total
station or any other device.
The port (1, 2 or 3) and the device are
displayed. Set the focus on GSI/ User
Out and press EDIT (F3) to modify the
GSI/ User Out port and device.
If you want to use a GSI/User Out
device set Use Device to YES.
Select the port to which the device is
connected. Use the DEVCE (F5) key to
configure the device itself.
Leica TPS300/700, Geodimeter and
Zeiss REC500 total stations as well as
the SOKKIA SDR33 datalogger are
currently supported.
When Leica TPS300/700 is selected
and connected to the GPS receiver,
select the Job Number to which job
the data should be sent. The Job
Name of existing jobs in the TPS
instrument is displayed. For a new job,
type in a name.
9.14 Interfaces - GSI/User Out
If data is being transferred to a
Geodimeter total station, then the
total station must be in a mode ready
to receive data.
SOKKIA devices can only handle
numeric point IDs. If Renumber is set
to YES, all points are transfered but
renumbered starting from 1. If NO is
selected, only points with numeric
point IDs are transfered and point IDs
are shortened to 4 digits, truncating
from the right.