Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 263)

263 10. Status Technical Reference Manual-4.0.0en
Moving Mode
5 Sats since - The length of time that
5 satellites have been observed for. In
Kinematic on the Fly operations, it is
important to observe 5 satellites for
about three minutes or so without
interruption at the beginning of the
chain.
GDOP - The current calculated value
for PDOP or GDOP.
Obs Rec Rate - The Observation
Recording Rate currently set.
Moving Obs - The number of Moving
Observations (epochs) recorded in
this interval.
Local Time - The local time is
displayed followed by the time latency
to UTC in brackets.
The position is then given. Use the
COORD (F2) key to switch between
WGS84 geodetic/Cartesian and local
coordinates. Note that local
coordinates are only available if a
local coordinate set has been defined.
Accuracy indicators for the current
position in horizontal and vertical
components are given.
Press VELCY (F4) to view velocity
information. Your velocity in the
horizontal and vertical directions is
given together with the bearing for the
horizontal direction.
Press TARGT (F6) to define and
navigate to a target. All functions are
available as in Real Time Point
Stakeout except for the fact that
positions cannot be recorded.
When working in advanced rover
mode, you may use the BLINE (F3)
key to see information about the
baseline. Baseline information,
however, can only be displayed if the
reference coordinate is sent as part of
the data format used for broad-
casting.
10.3 Position