Leica Geosystems GPS System 500 - Technical Reference Manual - Manual (Page 199)

199 7. Measuring with System 500 Technical Reference Manual-4.0.0en
Double Bearing, height included
If the height computation for a
hidden point has been enabled
within the configuration, the
following options apply in addition to
those on the previous page.
Delta Hgt - Height difference
between the center of the external
device and the aimed point.
Devices with inclinometer like the
Laser Locator will transfer the
measured height difference
automatically into this field as long
as Include Hgt in the panel
CONFIGURE\ Hidden Point is set
to YES. When working with devices
without inclinometer the height
difference can be estimated and
typed in manuallly.
Use the I/T H (F4) key to check or
enter the instrument height at the
standpoints A and B and target
heights.
The default values as defined in the
configuration are displayed but can
be edited. Use the DEFLT (F5) key to
reveal the default values again.
Trgt Height will only be available if
the settings have been done
accordingly in the configuration.
Otherwise, only the instrument height
will be taken into account.
CONT (F1) to return to the previous
panel and continue with the
calculation of the hidden point.
For further information on the Hidden
Point application and configuration
refer to Appendix H as well as
chapter 5.4.1.