Panasonic NAMPS HH950 User Manual
Page 57
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Signal c
Joe Doe
Signal
Joe Doe
2224444
1. To store phone numbers with a Name Tag, recall or
create a Name Tag by following the procedures
described previously. You may create your own Name
Tag, or use one from the Word List (see Table 3.2). Be
sure to press the ^
lph
) key when you’re done entering
the Name Tag.
2. Enter the phone number.
STO
=—==
+, - :Group
0-9,*:
Direct
STO : Enter
3. Press .
4. At this point, to store the information also by memory
location slot number, enter the desired two-digit
Memory Location Number.
STO 9 3 — -
Stored
5. Othenvise, press tsfo).
6. To escape from this mode, press (M)
NOTE:
To recall, enter
[
rcl
| (3D / (3D as
described later on page 3-30.
3-24 Speed-Dial Memory
Operation