Panasonic WV-CP160 - Manual (Page 11)

• Editing the SPECIAL Menu
To edit the SPECIAL menu (change set­
tings), proceed as for editing the CAM SET
UP menu above. Move the cursor to END
after the SET UP ENABLE appears. Then
press
^ and simultaneously for 2
seconds or more.
The SPECIAL menu appears on the moni­
tor. Select the item to be changed and
change the setting as described for the
CAM SET UP menu.
—
** SPECIAL **
UP SIDE DOWN OFF
CHROMA GAIN ___ I___
AP GAIN ___ I___
PEDESTAL .1......
HUE .1......
+
CAMERA RESET #PUSH sw
^RET END
J
Important Notice:
When the cursor is moved to END and the CAM SET UP menu closed after changing
the parameters, the new values are saved in the EEPROM (Electric Erasable and
Programmable Read Only Memory), These values remain valid until new values are
saved, even if the power of the camera is off.
SEHING PROCEDURES
1. Camera Identification (CAMERA ID) Setting
You can use the camera identification (CAMERA ID) to assign a name to the camera. The
camera ID consists of up to 16 alphanumeric characters. The camera ID display can be
selected on or off on the monitor screen.
r
** CAM SET UP **
CAMERA ID ;OFF, 1
ALC/ELC ALC ~l
SHUTTER OFF
AGC ON
SENS UP OFF
WHITE BAl АТИ 1
END SET UP ENABLE
V
Character Cursor
Pointer
To edit the CAMERA ID
1. Move the cursor to the CAMERA ID parameter.
2. Press El. The CAMERA ID menu appears. The cursor on the letter "0" is highlighted.
3. Move the cursor to the character you
want to edit or change by pressing
4. After selecting the character, press El.
The selected character appears in the
editing area. (The pointer in the editing
area moves to the right automatically at
this moment.)
5. Repeat the steps above until all charac­
ters are edited.
1Г234567ВЭ
ABCDEraHIJKUl
HOPQRSTOVWXYZ
0 ., ■•П;«#!?-
SPACE
FOSI RET END RESET
Character
Area
Command
Editing
Area
CAMERA ID menu