Cautions, Mounting from the top, Focus or flange-back adjustment – Panasonic WV-CP160 User Manual
Page 7: Installation of camera
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOCUS OR FLANGE-BACK ADJUSTMENT
The following adjustment should be made by qualified service personnel or system
installers.
1. Loosen the screw on the side of the
camera.
2. Turn the flange-back adjusting ring to
the desired position.
Caution;
Do not rotate the ring coun
terclockwise by force after it stops.
If the ring is rotated by force, the
inner lens or CCD image sensor
may be damaged.
3. Tighten the screw on the side of the
camera,
Cautions:
• Tightening the screw by force will cause damage to the screw or deviation of
focus.
* To use the C-mount lens, the Lens Mount Converter {C-mount adapter) WV-AD20
should be used with the camera.
INSTALLATION OF CAMERA
The mounting bracket can be fixed either on the top or bottom cover of the camera.
Fixing Screws
Mounting from the top
Remove the mount adapter from the bot-.
tom of the camera by removing the two fix
ing screws. The mounting hole is a stan
dard photographic pan-head screw size
(1/4" - 20). Attach the mount adapter to the
top as shown in the diagram, then mount
the camera on the mounting bracket.
Make sure that the two original fixing
screws are used when mounting the mount
adapter as longer length screws may dam
age inner components.
f ^