2. chroma level setting (chroma gain), 4. pedestal level setting (pedestal), 5. chroma phase (hue) setting (hue) – Panasonic WV-CP160 User Manual
Page 18: To reset to the factory settings (camera reset)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7-1. Camera Picture Upside Down Positioning (UP SIDE DOWN)
1. Move the cursor to the UP SIDE DOWN parameter.
2
.
Select ON when you desire to turn the picture upside down.
7-2. Chroma Level Setting (CHROMA GAIN)
1. Move the cursor to the CHROMA GAIN parameter.
2. While observing the vectorscope or color video monitor, move the T cursor to adjust
the chroma level.
7-3. Aperture Sharpness (Softness) Setting (AP SHARP/AP SOFT)
Note:
This item changes according to the position of the detail level selector
(SOFT/SHARHP) on the side of the camera.
1. Move the cursor to the AP SHARP (AP SOFT) parameter.
2. While observing the color video monitor, move the "I" cursor to adjust the aperture gain
level.
7-4. Pedestal Level Setting (PEDESTAL)
1. Move the cursor to the PEDESTAL parameter.
2, While observing the waveform monitor or color video monitor, move the "I" cursor to
adjust the pedestal level (black level).
7-5. Chroma Phase (Hue) Setting (HUE)
1. Move the cursor to the HUE parameter.
2. While observing the vectorscope or color video monitor, move the T cursor to adjust
the hue (chroma phase) level.
To reset to the factory settings (CAMERA RESET)
1. Move the cursor to the CAMERA RESET parameter. PUSH SW is highlighted.
2. While holding dowri ^ and
^ .
press
El
for 2 seconds or more. The camera is reset
to the factory settings.
To close the SPECIAL menu and return to the CAM SET UP menu
Move the cursor to RET and press El ■
To close the SPECIAL menu and return to the camera picture
Move the cursor to END and press El.