Panasonic NV-SD450B - Manual (Page 10)

Tuning the TV to your VCR
Operations
It is possible to view ttie video picture on your TV in the
same way that you watch TV broadcasts.
Jf you have connected the VCR to the TV&iroj^h the_______
scatfwmiinai. Then^yTO ?»'wnsea to wffewTtw - -
procedure mentioned below.
Preparation
•Turn on frteTV.
• Refer to the operating instruction of the TV set and carry
out tuning/preset procedure.
CD
Turn on the VCR.
RF ON—I
off ! O t EST signal
OFF---- i
To generate a test pattern, set RF OFF/
TEST SIGNAL to TEST SIGNAL ON.
On Screen Display
(During Auto Setup) (After Auto Setup)
Set the TV to an unused position which you
wish to use for your video playback.
•Tune the TV until the test pattern appears on the screen.
•On Panasonic TV the programme number 0 should be
selected to obtain best performance.
•When the VCR is turned on after connecting the aerial
lead and the mains lead. Auto setup (Auto tuning and
Auto clock setting) starts. (See next page.)
RF ON—I
O ff ITTITEST signal
OFF---- 1
Set RF OFF/TEST SIGNAL to TEST
SIGNAL OFF.
Note:
The test signal is transmitted on channel 36 of the UK
broadcasting channels. If you are encountering
interference from another broadcast on the video channel,
you may readjust to a free channel (30-42) by using the
CH ADJ. screw which is located on the rear of the VCR.
Please note that if the CH ADJ. screw is used then you
will have to retune your TV to the test signal as in item 2 to
4 above.
<
10
)