Panasonic NV-SD450B - Manual (Page 30)

One-Touch-Editing
With this editing, it is easy to perform repeated assemble
editing, insert editing or audio dubbing operations.
Preparations
• Before the VCR is connected to a movie camera or
another VCR, select One-Touch-Edit to ON.
(See page 37.)
The piayback VCR display or movie camera viewfinder
image may be abnormal if the edit cable is connected
with One-Touch-Edit left OFF.
•Connect a movie camera or another VCR to this VCR as
shown.
• Use the SYNC. EDIT socket when connecting this unit to
a VCR or movie camera equipped with a LANC socket.
•Insert a recorded cassette tape with an intact erasure
prevention tab.
•Select the video source required by pressing INPUT
SELECT to set A1, A2 or A3.
A1: 111 rough the AVI socket.
A2: Through the AV2 socket.
A3: Through the AV3 (AUDIO INA/IDEO IN) sockets on
front panel.
Recording VCR
Operations
-| Press PAUSE/STILL on the recording
VCR.
©
2 Search for the end of the previous
recording. ------------
3 Press REC to switch the VCR from the
pause mode to the recording standby
mode.
►The piayback VCR will be in still mode.
►If INSERT or AUDIO DUB is pressed Instead of
REC, Insert Editing or Audio Dubbing can be
performed-
4 Search for the Edit in (starting) point
on the playback VCR.
g Start One-Touch-Editing by pressing
PAUSE/STILL again.
©
6 Press PAUSE/STILL at the Edit out
(ending) point on the piayback VCR.
©
•For Editing in succession, repeat 4 to 6.
Press STOP to stop editing.
«w
©
<
30
>