Connecting to a desktop computer – Compaq MP1600 User Manual
Page 11
MP1600 Microportable Projector 1-5
Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 11/08/99 5:08 PM
Part Number:383706-001 File name: BkCh1.doc
Connecting the Projector to a
Desktop Computer
1. Connect one end of the projector signal cable
1B to the
projector and the other end to the VGA connector on the
desktop computer and tighten the screws.
✎
If your computer has a digital connector, connect one end of
the digital flat panel (DFP) signal cable
1A to the digital
connector on the projector and the other end to the digital
connector on the computer. Connect either the VGA cable OR
the DFP cable; do not connect both cables.
✎
Be sure the signal cable aligns with the connector. Do not force
the cable onto the connector or you may damage the signal
cable or the projector.
2. Connect one end of the power cord
2 into the back of the
projector, and the other end to an electrical outlet that is easily
accessible and close to the projector.
✎
For security purposes, this projector has been fitted with a slot
3
(located on the left, front side) for use with a security cable lock
that can be purchased separately at most computer stores.