Notes, Loading envelopes (labels, transparencies), Setup – Panasonic KX-P6100 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setup
Notes:
• If the paper guides are not adjusted properly, your printout may be skewed.
• Do not load paper of different types or thicknesses in the paper tray at one time, since this may cause a paper
jam.
• Wheri you want to add more paper to the paper tray, you must first remove the remaining paper from the tray
and then place the entire stack of paper into the tray.
• Make sure you load the paper with the print side up. Most paper has instructions recommending the side to
be printed first. When using 60 g/m^ (16 lbs.) paper, always load the paper with the “non-curl side” up rather
than following instructions on the paper package.
• For more detailed information on paper, refer to “Paper Specifications” ( P. 37).
• Do not allow more than 50 sheets [75 g/m^ (20 lbs.)] to accumulate in the output tray. This may cause a paper
jam.
o
fi)
a
5
’
(Q
T3
fi)
■a
(D
m
3
<
<D
O
T3
(D
tf)
Loading Envelopes (Labels, Transparencies)
You may load either 30 sheets of labels, 30 transparencies, or up to 10 envelopes in the paper tray.
You can use Business Commercial #10, Monarch, International DL and International C5 envelopes. For more detailed
information on Envelopes, refer to “Envelope Specifications” ( P- 39).
Notes:
• Before loading envelopes, make sure that all seams.are properly sealed to avoid turning over of the seams.
• The envelopes must be installed with the shorter edges first to avoid a paper jam.
• When installing envelopes, the flaps should be face down.
• To print lengthwise on the envelope (along the longer edge), set the printing mode to landscape
(cs^ P.18, 24).
Perform steps 1 and 2 on page 12.
2 Adjust the paper guides to the approximate
width of your enveiope.
Place the envelopes in the paper tray with the
sides to be printed facing up. Position them
between the paper guides and adjust the
guides until you feel resistance.
Verify that your envelope matches the paper
size set through the GDI Mode ( P- 18),
PCL Mode ( P. 24), or software applica
tion to avoid a paper jam.
13