Cleaning the printer, Outside of the printer, Turn the power off – Panasonic KX-P6100 User Manual
Page 31: Inside of the printer, Inside-of the printer, 6 care and maintenance, Chapter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter
6 Care and Maintenance
Cleaning the Printer
Periodic cleaning of the printer is recommended. The frequency of cleaning is dependent upon the environment. You
shouid clean the printer.
• at least once a month.
• when you install a new Process Unit.
• when print quality has deteriorated.
Outside of the Printer
Turn the power OFF.
2 Clean the cover with a soft cloth.
Use any mild commercial cleaner.
Caution:
• Do not use benzine, thinner, aerosol cleaners,
or any abrasive powder to clean the cabinet.
Inside of the Printer
^ Turn the power OFF.
Before cleaning the inside of the printer, allow
the fuser to cool (about 5 minutes).
2 Open the left cover.
Clean the following areas with a dry cloth or
a cotton swab.
With a dry cloth
• Pinch roller
• Feed roller
• Transfer roller
• Paper chute (Paper dust)
With a cotton swab
• Carefully wipe the tungsten wire by sliding a
cotton swab from end to end 4 to 5 times.
Pinch roller
Transfer roller
Feed roller
I
Tungsten wire
Cautions:
• The printer must be turned OFF prior to
cleaning.
• Do not expose the process unit to tight
for more than 5 minutes.
• Do not touch the green drum surface.
^ Close
the left cover.
31