Allocating virtual memory, Installing the kx-p6100 software, Setup – Panasonic KX-P6100 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setup
Allocating Virtual Memory
KX-P6100 software requires 12.5 MB of total memory, divided between your PC memory {a minimum of 4 MB) and
your Windows virtual memory. If your system has 4 MB of PC RAM, then you must allocate at least 8.5 MB of virtual
memory. If you have 5 MB of RAM, then you need at least 7.5 MB of virtual memory, and so on.
To change the virtual memory, follow the instructions below. For more information on virtual memory, refer to the
Optimizing Windows section in the Microsoft Windows 3.1 User’s Guide.
The following instructions assume your system has 4 MB of PC RAM.
Double click the Main icon from the Program
Manager screen.
Increase the New size in the New Settings
box to at least 8,500 KB.
2 Double click the Control Panel icon.
0
Double click the 386 Enhanced icon.
4 Ciick rVirtual Memory |.
Virtual Memory dialog box will be displayed.
'Y Select the Type “Permanent” in the New
Settings box.
g
Click
I
OK
I.
0 Click
I
Yes I.
g If the size shown in the Virtual Memory dialog
box is less than 8,500 KB, or Type is tempo
rary or none, then click [Change |.
Otherwise click Cancel to exit the dialog box.
10
Click
I
Restart Windows] to make the setting
effective.
Installing the KX-P6100 Software
To install the KX-P6100 software onto your hard disk, follow the instructions below.
^ At the DOS prompt, type WIN and press
(Enter ] to start Windows in the 386
Enhanced Mode.
On some PCs, you need to type WIN/3 at the
DOS prompt to set 386 Enhanced Mode.
Click the mouse or press any key to con
tinue.
0 Ciickthe button of the parailel port which you
wish to use, then click Connect
From the Program Manager menu, click File.
Then click the Run... option.
g Insert the KX-P6100 software disk #1 into
disk drive A.
A At the prompt, type A:\SETUP.EXE and click
y If you wish to install the KX-P6100 software
on default drive (C) and directory (KXP6100),
click
I
OKI.
If you wish to install the KX-P6100 software on
another drive and/or directory, type the letter
of the drive and/or directory name. Then click
OK .
14