Aviom 6416o - Manual (Page 50)

41 A
dvANced
F
uNctioNs
The red LED indicates that the system default sample alignment lock values
are being used.
To get sample alignment info, press the F
unCtion
button, followed by the
C
hannEl
11 a
CtivE
button. Press E
ntEr
; the LEDs in the Channel 11 meter strip
are used to indicate the current value in use.
The red (Clip) LED indicates that the system’s default •
values are being used. (This is set with Function 14.)
The green (Signal) LED indicates that stored values are
•
being used. (This is set with Function 13.)
Get New Sample Alignment Lock Value
To generate a new sample alignment lock value, use Function 12. This
Function can only be performed at the Control Master when the network is
unlocked.
Press the F
unCtion
button, followed by C
hannEl
12 a
CtivE
button. The sixteen
yellow channel meter LEDs and the Enter/Cancel LED will flash, indicating that
this operation will replace the currently stored value. Press E
ntEr
to generate
a new sample alignment value, or press C
anCEl
to exit without updating the
stored value.
Values are stored in each module’s memory but are not put into use until
Function 13 (Use Stored Sample Alignment Values) is performed, which
activates the stored sample alignment values. The module must be the
network Control Master to use its stored value. Use Function 11 to get info on
the current values in use.
When the stored sample alignment lock value is being used, a new sample
alignment lock value should be calculated each time the network sample rate