KEYENCE DL-PN1 - Manual (Page 17)

15 - PROFINET Communication Unit DL-PN1 User's Manual (IB) -
10 Reference light registration request DINT C
11 Adjust request DINT C
12 Adjust reset request DINT C
13 Reserved for system
14 Tolerance tuning request DINT C
15
Two-point turning HIGH side
1st request
DINT C
16
Two-point turning HIGH side
2nd request
DINT C
17
Two-point turning LOW side
1st request
DINT C
18
Two-point turning LOW side
2nd request
DINT C
19
Measured correction 1st
request
DINT C
20
Measured correction 2nd
request
DINT C
21 to 25 Reserved for system
26 Logical correction 1st request DINT C
27 Logical correction 2nd request DINT C
28 to 31 Reserved for system
32 Group1 Entry Count DINT R 29
33 Error status *1 DINT R
Bit0: Overcurrent error (ErC)
Bit1: EEPROM error (ErE)
Bit2: Sensor head error
Bit3: Transmitter/Receiver
reverse connection
error
Bit4: Transmitter internal
error
Bit5: Receiver error
Bit6: Transmitter error
Bit7: Transmitter laser error
Bit8: Model mismatch error
Bit9: Reference light
registration error
Bit10: Adjust error
Bit11: Amplifier
communication error
34 Warning status DINT R
0: Check output OFF
1: Check output ON (in N.O.)
35
Warning function operating
state
DINT R
0: Check output function disabled
1: Check output function enabled
36
Judgment output/Check
output *2
*20
DINT R
Bit0: HIGH judgment output
0: OFF, 1: ON
Bit1: LOW judgment output
0: OFF, 1: ON
Bit2: GO judgment output
0: OFF, 1: ON
Bit3: Check output
0: OFF, 1: ON
37 Current value (P.V. value)
*3
*4
DINT R -999.99 to +999.99
38 Raw value (R.V. Value) *4 DINT R -999.99 to +999.99
Index
(DEC)
Function name Description
Data
type
Attribute
Default
value
Value