ALTANA LCM III - Manual (Page 29)

28
Standard Operations
1. Press PC & Printer in the Instrument Setup.
2. Select PC.
3. Press Setup to display the PC Setup screen.
For further installation instructions, refer to the Data Trans user
manual.
4. Select Auto-Send: On to send all measured data automatically
to the PC.
Note: If Auto-Send: Off is selected, the "PC & Printer" key must be
pressed, in order to send data to the PC.
The remote function is only for monitoring the data transfer.
5.3.4 Delete stored data from the data log
1. Press Recall Data in the Main Menu.
2. Press Data Log, then Options>Delete.
3. Highlight Single Point or Filtered data or All data and press
OK to confirm.
Note: The number in parentheses is the total number of data sets
assigned to this selection.