ALTANA Spectro-Guide Sphere Gloss Manual - Manual (Page 18)

17
Getting started
5. Getting started
5.1 Turning on and measuring
The device is switched on with the Operate button.
The company logo, copyright notice and version
number appear. The instrument then enters into the
ready-to-measure state.
The display indicates the difference measurement.
This is the default setting for the basic version. The
measurement data for the sample are shown on the
left side of the display, while the differences to the
last measured standard appear on the right side. At
this point, you can use the Operate button (the large
button) to start the measurement of the sample. As
an alternative, you can perform the measurement
with the automatic trigger by pressing on the
instrument as illustrated here.
You can perform a quick standard measurement
with the button.
First, the absolute values of the standard are
displayed. If you perform a sample measurement at
this point, the measurement data for the sample will
be shown on the left side. The right side of the
display will show the differences between this
sample data and the standard which has just been
measured.
std
File Display Option
L* 92.45 L* 0.04
a* 0.46 a* 0.01
b* - 1.55 b
*
0.03
E 0.05 D65/10°
Δ
Δ
Δ
Δ
Sample
*
std