ALTANA Spectro-Guide Sphere Gloss Manual - Manual (Page 43)

42
Options
10.3 Gloss
From the “Options” menu, use the button
to move the cursor to the “Gloss” option.
The submenu will open when you press the Operate
button. Move the cursor to “Gloss on” and confirm
your choice by pressing the Operate button.
The instrument will return to the measuring mode.
If you are in the “Display/Sample Mode” and take a
reading with the Operate button, the display will
show the values of the sample.
You can now either save the measured value as
Standard or as Sample. See Chapter 7.2.
When entering the tolerances you will also be
prompted to enter a gloss range.
Enter the respective values and confirm your choice
by pressing the Operate button.
If you are in the “Display/Differences” mode, the
color and gloss values of the sample are displayed
on the left side, and the differences to the standard
are shown on the display’s right side.
The color and gloss tolerances are taken into
account in the Pass/Fail mode. If the gloss value is
outside the entered tolerance range, a message will
be displayed in the form of
↑ (higher gloss) or ↓
(lower gloss).
File Display Option
Input tolerances
Gloss 080.0 085.0
01.02
ΔE*
File Display Option
L*
a*
b* 93.72
-1.49
0.21
D65/10°
G 86.6
File Display Option
L*
a*
b*
E*
Δ
Δ
Δ
Δ E* Δ
Δ G Δ
0.04
0.01
0.03
0.05
0.05
Sample
*
*
*
* *
G
L*
a*
b*
D65/10°
G
*
*
*
G
92.45
0.46
-1.55
3.9
File Display Option
L*
a*
b*
E*
Δ
Δ
Δ
Δ E* Δ
0.04
0.01
0.03
0.05
*
*
*
* *
Fail
D65/10°
G G 2.7 ↑
std