Avlink HRM-602P - Manual (Page 16)

H H H R R R M M M - - - 6 6 6 0 0 0 2 2 2 P P P
15
Slave Channel Port selection:
Press the “0” + Number#1~6 button to select the channel to the Slave channel.
Example: Press the “0” button on the Remote controller first, then press the “3” button to
select the channel#3 input signal to the Slave channel. (Only available with PIP mode
1~7).
5.3 Rear Panel
Figure 5-10 HRM-602P Switcher Rear Panel
The HRM-602P Switcher supports up to 6 input and 1 output jacks (HDMI Type A) on the
rear panel, each female terminals separately form the signal input and output jacks. The
signal input connector are numbered as “HDMI1~6” for signal input. The input terminals
supply you to connect to different equipments including CD/DVD players, Blue Ray
player, PS3, Video Camera, STB and so on. The output terminal with HDMI and VGA
interface can be connected to projectors, video recorders, multiplexers and other
displayers.
 12 DC power port: The Power Port is applicable for 100~240VAC, 50~60Hz
connected to the outlet of power source. Refer to 6.4 Power Connection .
 HDMI1~6 connectors: The HRM-602P Switcher Input connectors are connected to
the DVDs, CD players, PS3 or other input sources.
 HDMI OUT connector: The HRM-602P Switcher Output connector is connected to the
A/V, HDTVs or other output devices.
HDMI Type A Connector pin definition:
Pin # Signal Pin # Signal
1 TMDS Data2+ 11 TMDS Clock Shield
2 TMDS Data2 Shield 12 TMDS Clock-
3 TMDS Data2- 13 NC
4 TMDS Data1+ 14 NC
5 TMDS Data1 Shield 15 DDC-SCL