Avlink HRM-602P User Manual
Page 17
H
H
H
R
R
R
M
M
M
-
-
-
6
6
6
0
0
0
2
2
2
P
P
P
16
6
TMDS Data1-
16
DDC-SDA
7
TMDS Data0+
17
DDC-Ground
8
TMDS Data0 Shield
18
+5V Power
9
TMDS Data0-
19
Hot Plug Detect
10
TMDS Clock+
VGA OUT connector: The VGA OUT connector is connected to the Monitor, HDTVs or
other output devices through a VGA cable.
AUDIO OUT port: This port is connected to the speaker, microphone or other audio
output devices
RS-232 connector: Use a 9-pin RS-232 cable to connect both computer serial port
(COM1 or COM2) and the HRM-602P’s RS-232 communication connector, refer to
6.5.1 RS-232.
The computer can then be deployed to control the HRM-602P after
installing of application software. Refer to
7.1 Software Introduction
for a software
control or
Appendix C RS-232 Communication Protocol
for an individual configuration.
SETTING switcher: Supports an eight pins DIP switcher for Switcher connection
configurations. For more information, refer to
6.5 Ports and Switchers
.
-
Pin 1: IP Reset
-
Pin 2~3: RS-232/LAN
-
Pin 6~Pin8: ID
IR port: This is used for connecting the IR Receiver. Refer to
6.3 IR EXT Connection
.
Figure 5-11 IR Receiver Pin Definition
LAN Port: Use the RJ-45 connection cable to connect the Internet and the HRM-602P
Switcher. The entire PC at the same network can control the HRM-602P Switcher
through the LAN port. Refer to
6.5.2 LAN Port
.