2 lan port, 3 dip switcher 8 pins – Avlink HRM-602P User Manual
Page 23
H
H
H
R
R
R
M
M
M
-
-
-
6
6
6
0
0
0
2
2
2
P
P
P
22
6.5.2 LAN Port
The HRM-602P Switcher supports a network RJ45 registered jack using 8P8C modular
connector, which specifies the physical male and female connectors as well as the pin
assignments of the wires in a telephone cable. (A common LAN cable is available.)
Figure 6-10 LAN Port
6.5.3 DIP Switcher 8 Pins
Figure 6-11 DIP Switch
A. DIP Switcher Pin 1: Reset the web server IP address to 192.168.0.3
The steps are as below:
1. Please adjust the pin1 to ON and re-start the HRM-602P Switcher
2. After the HRM-602P Switcher re-starts about 10 seconds, shut down your
equipment.
3. For a normal operation, please adjust the pin1 to OFF, then power on the
HRM-602P Switcher again. The IP address will be restored to the default value:
192.168.0.3