Avlink HX-2344Z - Manual (Page 14)

S E AM L E SS HDBAS E T M AT RIX S W IT CHE R – HX - 2 344Z
13
5.2 Rear Panel
Figure 5-2 HX-2344Z Rear Panel
HX-2344Z supports up to 4 output jacks (RJ-45) on the rear panel, each female terminal
separately form the output jacks. HX-2344Z terminal channels numbered as OUT1~4 are
for signals output. The input terminal supplies you to connect to different equipment
including CD/DVD player, Blue Ray player, PS3, Video Camera, STB and so on.
 Power port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source. Refer to 6.4 Power Connection .
 Power switcher: To switch power ON or OFF the Matrix Switcher.
 IR Tx1~4 ports: Used to connect to the IR Blaster cable for IR pass-through.
Figure 5-3 IR Blaster Pin Definitions
 IR Rx1~4 ports: Used to connect to the IR Receiver cable for IR pass-through.
Figure 5-4 IR Receiver Pin Definitions
 IR EXT port: This is used to connect the IR Receiver Cable for the Matrix Switcher
Remote Controller.
 Input ports (HDMI1~4): You can use the HDMI input ports to connect the CD/DVD
player, Blue Ray player, PS3, Video Camera, STB and so on.
 Output ports (OUT1~4): You can use the output RJ-45 ports for over long connections