Avlink HX-2344Z - Manual (Page 15)

S E AM L E SS HDBAS E T M AT RIX S W IT CHE R – HX - 2 344Z
14
via the extensible accessory devices.
 RS-232: Use a 9-pin RS-232 cable to connect both computer serial port (COM1 or
COM2) and Matrix Switcher RS-232 communication port, refer to 6.7.1 RS-232 . The
computer then can be deployed to control the Matrix Switcher after installing of
application software. Refer to 7.1 Software Introduction for a software control or
Appendix E RS-232 Communication Protocol for an individual configuration.
 RS-485: Connection ports allow you to connect/control more than one Matrix product,
refer to 6.7.2 RS-485 .
 LAN port: Use the RJ-45 connection cable to connect both of the PC and the Matrix
Switcher for an Internet configuration. The entire PCs at the same network can control
the Matrix Switcher through the LAN port. Refer to 6.7.4 LAN Port .
 Switchers: The HX-2344Z supports 2 sets of 8 pins DIP switcher and a 3 pins DIP
switcher for connected configurations. For more information, refer to 6.7 Ports and
Switchers
 RxGTx: Use the transmission line with RS-232 to connect the remote control PC for a
data transmission between local and remote.
- Rx: Receive RS-232-level signal pin. (data in)
- G: GND
- Tx: Transmit RS-232-level signal pin. (data out)