2 switcher configuration – Avlink HX-2344Z User Manual
Page 32
S E AM L E SS HDBAS E T M AT RIX S W IT CHE R – HX - 2 344Z
31
Figure 7-1 AV Matrix Installation Window
7.1.3 Connect HX-2344Z and PC
You must power off the HX-2344Z Switcher. Then, connect the Switcher RS-232 port to
the PC RS-232 port with the bundled communication cable. And make sure the DIPs on
the rear panel are set to Master and RS-232. (Refer to the previous section
6.7.1
RS-232
)
7.2 Switcher Configuration
After finishing installation, click
to active AV Matrix Application. In the
“Options” window, select the connected PC Port number and Baud rate, and then click
“OK”.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below: