Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 13)

Rear Panel Overview
Rear panel overview and descriptions highlighting important connectors and ventilation areas:
8
Left In Left Out AES OUT AES IN Right In Right Out Midi
AC Power 100-240V
C E Analog In Analog Out Digital I/O Handcrafted in the USA
remote loop thru
1 2 3 4 5 6 7
1. Fan
Outlet WARNING!
The fan exhaust outlet. Do not block or obstruct this opening. Keep clear and clean.
2. AC
Inlet/Fuse WARNING!
IEC standard grounded AC power inlet with fuse. Fuse must be the correct type for the voltage
set, see rear panel. APPLY ONLY THE AC VOLTAGE AS SET BY THE MANUFACTURER.
3. MIDI
I/O
MIDI in and out. These have no function for V1 and are reserved for future enhancement and
functions.
4. AES Digital I/O
Balanced AES single wire digital I/O. Self clocking, supports sample rates from 44.1k to 192k.
5. Remote / Remote loop thru
RS 422 serial port for the dedicated M10 remote console. Provides control data and power for the
remote. Loop through connector is for connecting up to 4 M7 mainframes to one remote.
6. Analog
Outputs
2 Balanced analog audio outputs on industry standard XLR type connectors.
7. Analog
Inputs
2 Balanced analog audio inputs on industry standard XLR type connectors.
8. Rear Air Inlets
WARNING!
Fresh air inlets from the rear panel. DO NOT BLOCK OR OBSTRUCT as overheating may
result.
1-2