Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 21)

Selecting a Preset Program
The first thing you may want to do is browse through the preset programs and select one that you
want to hear. The “out of the box” default is set to Large Hall 01 in the Hall bank of programs.
Prog:
Press the Prog (program) key. This will bring you to the program select mode. If you
are in another display, such as System, pressing the Prog key will bring you to the
program select state and display the last program viewed or accessed. If it is the current
running program there will be no * displayed. If it is not the current running program, or
when browsing for a new preset, the upper program display will show an * if the program
displayed is not the current running one. Pressing Prog will take you home and display
the current running program.
Adjust Knob:
In program mode, turning the adjust knob will step you through the presets one by one,
displayed on the upper section. You can simply turn the knob either direction until you
see a program that you want. This will rotate through the programs in the bank that has
been selected by the cursor keys. For example if HALLS are selected, the knob will only
move through presets in the HALLS bank until the bank is changed. Pressing the Enter
key will load the program selected. If the program is not loaded, there will be an * at the
last character display to the right, indicating that the program is not the one that is
running. Pressing Prog will bring the display back to show the current running program.
Cursor Keys:
The cursor keys will step through banks of programs. This allows for quick access to the
type of program you want, by selecting the type and not having to scroll through all
programs one by one.
The BANK information is displayed on the lower display. Pushing one the cursor keys up
or down will change the display to show the BANK information: HALLS, PLATES,
ROOMS, etc. After selecting a BANK, you can then browse through the programs in that
bank with the adjust knob and press Enter if you want to load that preset for listening.
Enter:
As described above, pressing Enter will load the program displayed. On the upper
display the * will disappear when the new preset is loaded, showing the loaded preset
name without the *.
Example of the display in program select mode .
L a r g e H a l l * PROG
ENTER
H a l l s
Displays program group Program name Program Load * Steps through Banks Adjust Knob Scrolls
through pgms.
2-2