Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 24)

Using the Registers
You can also use the user storage locations called registers. Storing an edited program here
allows for up to 50 user storage locations, arranged in Banks and Registers, and permits the user
to label the new version.
Display example in Register mode:
R E D R O O M 0 *
B a n k 0
Bank and number Name and reg number, status * Cursor keys
The lower display shows the bank number, and the upper display is writeable and is used
for the name of the original program, or your custom label, and the register number.
Quick Save to Register:
While in EDIT, or PROG mode, simply press Reg. You will be taken to the user
registers. The factory default is for all register locations to be clear, so if this were the
first time you stored something it would bring you to BANK 0, REG 0. Or, if you have
used the registers, it will go to the last register location viewed or accessed. Pressing
Store will store that edited preset in that location with the original name. As in selecting
programs, there will be an * if the register is unused or not running.
Store to a specific Location:
There are 5 Banks of 10 registers for storage locations, so you can choose the right place
to store your edited effects along with others of similar type or from the same session,
etc.
To choose a different location, turn the adjust knob to find a suitable register location in
that bank (an * is visible if the register is unused or not running) then press Store and the
program will be stored in the new location in that bank and the * will disappear. If you
want to use a new bank, use the cursor keys to step to another bank, then turn the adjust
knob to find a register location in that bank and press Store. If you choose a location that
has an effect stored in it, this will overwrite any previous program stored at that location.
Store with a New Label:
As described above, press Reg and you will be taken to the last storage location viewed
or accessed. If desired, choose a different location with the adjust knob and or cursor
keys, and then press Store to save it. Press Reg again. Pressing Reg twice takes you to
the labeling page and you will see the first character in the upper display flash. Use the
adjust knob to choose a character, use the cursor keys to step through the 14-character
location display. Press Enter when you have the desired name chosen to save the new
name. This will only save the name and will not affect any parameter value changes.
2-5