Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 28)

System Mode-Parameters
•
Audio Format: Selects the input type and how the M7 will react to them in both
settings.
Analog:
Selecting this parameter will tell the M7 that regardless of what is connected to either
the analog or digital inputs the M7 will use the analog inputs and outputs. When
using this mode, the M7 will AWAYS run at the optimal sampling rate to obtain the
best possible analog audio performance and sound characteristics.
Digital:
Selecting this parameter will tell the M7 that if there is a valid AES digital audio data
stream connected to the digital inputs the M7 will use the digital input. When there is
a valid signal present the M7 will sample at the incoming sample rate and lock to that
external clock.
ƒ If the digital input is removed, or fails for some reason, the M7 will mute the
outputs.
ƒ If the digital input is renewed with a valid data stream, the M7 will switch back
to the digital inputs with no glitches.
To set, turn the adjust knob to select the input type and press Enter.
•
Digital Status: Displays the sample rate the M7 clocked to when syncing to an
external source, or the sample rate of the A/D conversion when using the analog inputs .
Displays status only, there are no adjustments.
•
Analog Out Level: Sets the analog output level in three steps to match the input
sensitivity of the mixer:
HIGH +24dB MED +16dB LOW +8dB
To set, turn the adjust knob to select the desired level and press Enter.
•
Display Level: Sets the intensity of the front panel display text in 5 levels:
Dim 1 2 3 Bright
To set, turn the adjust knob to select the level you want and press Enter.
2-9