Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 17)

Audio I/O
Using and setting the Digital Inputs
The factory default settings of the M7 I/O are set to analog in. If there is a digital input and
output connected to the M7, you must select the Audio Format type and change the internal
patching in the M7 to Digital. This will set the M7 to use AES digital in and out as its audio I/O
path.
Press the System key and use the cursor keys to step through the menu to find Audio Format. Use
the knob to select Digital, press Enter to set the value. The digital inputs of M7 will accept any
AES single wire data stream with sample rates from 44.1k to 192k and is displayed on the Digital
Status display by pressing the down key to move to the next screen.
EDIT
A u d i o F o r m a t
D i g i t a l
Value Parameter selects parameter Adjusts value
ENTER
Sets value
Using and setting the Analog Inputs
If the M7 is set to Analog, follow the same procedure described above to set the digital, but
choose Analog. In this mode, the M7 will ignore the digital input and outputs and switch and
connect to the analog inputs and outputs.
EDIT
A u d i o F o r m a t
A n a l o g
Value Parameter selects parameter Adjusts value
ENTER
Sets value
Note:
You must choose to use either the analog or digital audio I/O. You can not mix these formats and
use analog in to digital out, or digital in to analog out.
1-6