Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 26)

Setting System Parameters
There are parameters that may need to be adjusted from time to time that have a global effect on
the way the M7 operates. These are under the SYSTEM menu and navigating these is similar to
loading preset programs and registers. In this case, when a parameter is changed and not set by
pressing Enter, the * will appear to show that the change is displayed but not active.
Accessing the SYSTEM parameters:
Press the key labeled System.
• The upper display will show the parameter type.
• The lower display will show the value of the parameter.
• Using the cursor keys will step though the parameter types.
• Using the adjust knob will adjust the parameters.
• Pressing Enter will set the parameter that has been selected using the adjust knob.
• An * will appear when a parameter displayed is not the active one.
Note: An important difference between editing a program and adjusting system parameters is
that, unlike editing programs, pressing Enter sets the parameter value. These are global
parameters and you may want to browse through and see where the parameters are set
and NOT change their value. Keep in mind that pressing Enter will set that parameter.
A n a l o g O u t L e v e l
EDIT ENTER
+ 2 4 d b
Lower display Upper display Cursors Selects Adjust knob Sets value
Parameter Value Parameter type Parameter type Adjusts parameter
Table of system parameters:
Dry Gain Wet Gain Audio Routing Audio Format Digital Status
Analog Out
Level Display Level Lock Reg Bank Unlock Reg
Bank Clear Reg
Bank
2-7