Bricasti Design M7 Mainframe Stereo Reverb Processor Owner’s Manual - Manual (Page 22)

Editing a Preset Program
The next thing you might want to do is to edit the program to better suit your needs.
Edit Key:
In order to edit a program you must be in PROG or REG and not in SYSTEM, as you are
editing a preset program or one that you have previously stored in a user register and not
editing system parameters.
Press Prog. This will bring you to the program menu.
Press the Edit key. This will bring you to the edit page of the current running program.
• The upper display shows the parameter type.
• The lower shows the current value for the parameter.
Cursor Keys:
The cursor keys will step you through the available parameters for that program, shown
on the upper display.
Adjust Knob:
Turning the adjust knob will adjust the parameter value shown on the lower display.
Example of the display in reverb time adjust mode
EDIT
R E V E R B T I M E
2 . 4 0 S E C
Parameter value Parameter type Selects type Adjusts value
• The edited program will remain running in its edited state, even when cycling power on
and off or in the event of a power loss, until you either store it or load a new preset or
register program.
Table of all user reverb parameters as they appear in the menu:
Reverb Time Size Pre Delay Diffusion Density
Modulation Rolloff HF RT
Multiply
HF RT
Crossover LF RT
Multiply
LF RT Crossover VLF Cut Early/Reverb
Mix Early Rolloff Early Select
2-3