Programming transmitters to the vehicle – Cadillac 2011 DTS User Manual

Page 107

Advertising
background image

Black plate (5,1)

Cadillac DTS Owner Manual - 2011

Q

(Lock): Press to lock all the doors. If enabled

through the Driver Information Center (DIC), the parking
lamps may flash once to indicate locking has occurred.
The horn may chirp when

Q

is pressed again within

five seconds. See DIC Vehicle Customization on
page 4‑74
for additional information.

Pressing

Q

may arm the content theft-deterrent system.

See Content Theft-Deterrent on page 3‑18.

K

(Unlock): Press once to unlock the driver door. If

K

is pressed again within five seconds, all remaining
doors unlock. The interior lamps come on and stay on
for 20 seconds or until the ignition is turned on.
If enabled through the DIC, the parking lamps flash
twice to indicate unlocking has occurred. See DIC
Vehicle Customization on page 4‑74
. Pressing

K

may

disarm the content theft-deterrent system. See Content
Theft-Deterrent on page 3‑18
.

V

(Remote Trunk Release): Press and hold for

about one second to unlock the trunk. The transmission
must be in P (Park).

L

(Vehicle Locator/Panic Alarm): Press and release

to locate the vehicle. The turn signal lamps flash and
the horn sounds three times.

Press and hold

L

for more than two seconds to

activate the panic alarm. The turn signal lamps flash
and the horn sounds repeatedly for 30 seconds. The
alarm turns off when the ignition is moved to ON/RUN
or

L

is pressed again. The ignition must be in LOCK/

OFF for the panic alarm to work.

The vehicle comes with two transmitters. Each
transmitter will have a number on top of it, “1” or “2”.
These numbers correspond to the driver of the vehicle.
For example, the memory seat position for driver 1 will
be recalled when using the transmitter labeled “1”,
if enabled through the DIC. See Memory Seat, Mirrors
and Steering Wheel on page 2‑6
and DIC Vehicle
Customization on page 4‑74
for more information.

Programming Transmitters to the
Vehicle

Only RKE transmitters programmed to the vehicle will
work. If a transmitter is lost or stolen, a replacement can
be purchased and programmed through your dealer.
When the replacement transmitter is programmed to the
vehicle, all remaining transmitters must also be
programmed. Any lost or stolen transmitters no longer
work once the new transmitter is programmed. Each
vehicle can have up to eight transmitters programmed
to it. See RELEARN REMOTE KEY under DIC
Operation and Displays on page 4‑58
.

3-5

Advertising