Flash-to-pass, Windshield wipers, Flash-to-pass -10 windshield wipers -10 – Cadillac 2011 DTS User Manual

Page 168

Advertising
background image

Black plate (10,1)

Cadillac DTS Owner Manual - 2011

Flash-to-Pass

This feature lets you use the high-beam headlamps to
signal the driver in front of you that you want to pass.

The flash-to-pass feature will only work with the
headlamps on. It does not work with Daytime Running
Lamps (DRL).

Pull and hold the turn signal lever toward you to use.

If the headlamps are on low beam, pulling the turn
signal towards you will flash the high beams.

Windshield Wipers

The windshield wiper lever is located on the left side of
the steering column.

Turn the band with the wiper symbol on it to control the
windshield wipers.

8 (Mist): For a single wiping cycle, hold it on mist until
the wipers start, then release. The wipers stop after one
wipe. Several wipes, hold the band longer.

6

(Delay): Use to set the delay time between wipe

cycles. The wiper speed can be set for a long or short
delay between wipes. The closer the band is set to the
top of the lever, the shorter the delay.

6 (Low Speed): Slow wipes.

1 (High Speed): Fast wipes.

9 (Off): Turns the wipers off.

Clear ice and snow from the wiper blades before using
them. If frozen to the windshield, carefully loosen or
thaw them. Damaged blades should be replaced.

Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it cools.

The vehicle has wiper-activated headlamps. After the
windshield wipers have completed eight wipe cycles
within four minutes, the headlamps automatically turn
on. See Wiper Activated Headlamps on page 4‑26 for
more information.

4-10

Advertising