Cadillac 2011 DTS - Manual (Page 39)

Black plate (7,1) Cadillac DTS Owner Manual - 2011
To recall, press and release “1” or “2.” The vehicle must
be in P (Park). A single beep will sound. The seat,
outside mirrors, and steering column will move to the
position previously stored for the identified driver.
Memory Remote Recall
This feature can recall the driver seat, outside mirrors,
and power tilt wheel, if available, to stored positions
when entering the vehicle.
To activate, unlock the driver door with the Remote
Keyless Entry (RKE) transmitter. The driver seat,
outside mirrors, and steering column will move to the
memory position associated with the transmitter used to
unlock the vehicle.
The automatic recall feature can be turned on or off
using the vehicle customization menu. See “Memory
Seat Recall” DIC Vehicle Customization on page 4‑74
for more information.
To stop recall movement, press one of the power seat
controls, memory or power mirror buttons, or the power
steering column control.
If something has blocked the driver seat and/or the
steering column while recalling a memory position, the
recall may stop. Remove the obstruction; then press
and hold the appropriate manual control for the memory
item that is not recalling for two seconds. Try recalling
the memory position again by pressing the appropriate
memory button. If the memory position is still not
recalling, see your dealer for service.
Easy Exit Driver Seat
This feature can move the seat rearward and the power
tilt wheel, if equipped, up and forward to allow extra
room to exit the vehicle.
S (Easy Exit Driver Seat): Press to recall the easy exit
seat position. The vehicle must be in P (Park).
If the easy exit seat feature is programmed on in the
vehicle customization menu, automatic seat and
steering column movement occur when the ignition
key is removed.
A single beep sounds. The driver seat will move back,
and if the vehicle has the power steering column and
telescopic steering feature, the steering column will
move up and forward.
If something has blocked the driver seat while recalling
the exit position, the recall may stop. Remove the
obstruction; then press and hold the power seat control
rearward for two seconds. Try recalling the exit position
again. If the exit position is still not recalling, see your
dealer for service.
See “Easy Exit Recall” and “Easy Exit Setup” under DIC
Vehicle Customization on page 4‑74 for more
information.
2-7