Cadillac 2011 DTS - Manual (Page 248)

Black plate (90,1) Cadillac DTS Owner Manual - 2011
EQ (Equalization): For the non-Bose ® amplified radio,
perform the following steps to setup the equalization
settings:
1. Press the
a
knob until the equalization label
displays.
2. Press the pushbutton located under the
equalization label to get choices of POP, ROCK,
CTRY (country), TALK, JAZZ, and CLAS
(classical), to display.
3. Press the pushbutton located under the desired
setting.
For the Bose amplified radio, perform the following
steps to setup the equalization settings:
1. Press the
a
knob until the DSP label displays.
2. Press the pushbutton located under the DSP label
to get choices of Norm, Driv, Rear, and Surround,
to display.
3. Press the pushbutton located under the desired
setting.
To select Surround, press either the fourth or fifth
pushbutton located under the displayed Surround
until Centerpoint displays.
To return to the manual mode, press the tune knob.
Select either BASS, MID, or TREB and start to manually
adjust the settings by turning the
a
knob.
Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade): To adjust balance or fade,
press the
a knob until the speaker control labels
display. Continue pressing to highlight the desired label,
or press the pushbutton positioned under the desired
label. Turn the
a knob to adjust the highlighted setting.
The highlighted setting can be adjusted by pressing
either SEEK arrow,
\
FWD, or
s
REV buttons until
the desired levels are obtained.
To quickly adjust balance or fade to the middle position,
press the pushbutton positioned under the BAL or
FADE label for more than two seconds. A beep sounds
and the level adjusts to the middle position.
To quickly adjust all speaker and tone controls to the
middle position, press the
a knob for more than
two seconds until a beep sounds.
Digital Signal Processing (DSP)
This feature is used to provide a choice of four different
listening experiences. DSP can be used while listening
to the audio system or a CD. To change the DSP mode,
press the
a
knob until the DSP control label displays.
Press the pushbutton located under the DSP label until
the control labels display. Continue by pressing the
desired button below the control labels on the display.
4-90